@article {Moreno201578,
	title = {{Quaternary tectonic activity of the Carboneras Fault in the La Serrata range (SE Iberia): Geomorphological and chronological constraints}},
	journal = {Tectonophysics},
	volume = {663},
	year = {2015},
	pages = {78{\textendash}94},
	abstract = {The Eastern Betic Shear Zone (EBSZ) in Southern Iberia is known to accommodate part of the 4-5mm/yr convergence between Africa and Iberia, but its seismic hazard is not sufficiently understood for an accurate risk assessment. One of the main structures of the EBSZ, the left-lateral 150km-long Carboneras Fault, displays no clear instrumental and historical activity despite being morphologically expressive. Detailed geomorphological mapping, geochronological analysis, and structural observation on the La Serrata segment of the Carboneras Fault were designed to investigate its recent evolution. Quaternary sediments and geomorphic features were targeted and 42 new numerical ages were obtained based on 66 samples (thermoluminescence, U-series, 14C, 10Be). The chronological framework of La Serrata was constructed by combining these numerical ages with a conceptual model previously developed in the region, which assumes that alluvial fan aggradation was produced during cold and dry periods (glacials and stadials), whereas stability and phases of calcrete formation were favored during warm and wetter periods (interglacials and interstadials). The spatial distribution of dated alluvial fans suggests an early phase of uplift that probably occurred between 1Ma and 56.6ka in the northeastern portion of the study area, whereas in the southwest sector the main uplift phase occurred later than 110.3ka. A decline in fault activity would have taken place after 30.8ka. Vertically offset dated units indicate minimum dip-slip rates of 0.05mm/yr and 0.18mm/yr, averaged for the last 1Ma and the last 110.3ka, respectively. Deflected channels and associated dated units yield a minimum left-lateral strike-slip rate of 1.31mm/yr, averaged for the last 110.3ka. The most recent fault movement of the fault could be younger than AD 637. Our results suggest therefore that the Carboneras Fault is among the fastest in Iberia, and should be considered in future hazard analyses. {\textcopyright} 2015 Elsevier B.V.},
	doi = {10.1016/j.tecto.2015.08.016},
	url = {http://www.scopus.com/inward/record.url?eid=2-s2.0-84955683900\&partnerID=40\&md5=e4a4acb51d89920f2e6fbd0c738b7730},
	author = {Moreno, X.a b and Masana, E.a and Pall{\`a}s, R.a and Gr{\`a}cia, E.b and Rod{\'e}s, {\'A}.a c and Bordonau, J.a}
}
@article {Garcia-Mayordomo2012,
	title = {{The Quaternary Active Faults Database of Iberia (QAFI v.2.0)}},
	journal = {Journal of Iberian Geology},
	volume = {38},
	number = {1},
	year = {2012},
	month = {sep},
	pages = {301{\textendash}318},
	abstract = {The Quaternary Active Faults Database of Iberia (QAFI) is an initiative lead by the Institute of Geology and Mines of Spain (Instituto Geol{\'o}gico y Minero de Espa{\~n}a, IGME) for building a public repository of scientific data regarding faults having documented activity during the last 2.59 Ma (Quaternary). QAFI also addresses a need to transfer geologic knowledge to practitioners of seismic hazard and risk in Iberia by identifying and characterizing seismogenic fault-sources. QAFI is populated by the information freely provided by more than 40 Earth science researchers, storing to date a total of 262 records. In this article we describe the development and evolution of the database, as well as its internal architecture. Additionally, a first global analysis of the data is provided with a special focus on length and slip-rate fault parameters. Finally, the database completeness and the internal consistency of the data are discussed. Even though QAFI v.2.0 is the most current resource for calculating fault-related seismic hazard in Iberia, the database is still incomplete and requires further review.},
	keywords = {Active fault, Iberia, Portugal, Quaternary, Seismic hazard, Spain},
	issn = {1886-7995},
	doi = {10.5209/rev\_JIGE.2012.v38.n1.39219},
	url = {http://www.scopus.com/inward/record.url?eid=2-s2.0-84861912592\&partnerID=tZOtx3y1},
	author = {Garc{\'\i}a-Mayordomo, J. and Insua-Ar{\'e}valo, J.M. and Mart{\'\i}nez-D{\'\i}az, J.J. and Jim{\'e}nez-D{\'\i}az, A. and Mart{\'\i}n-Banda, R. and Mart{\'\i}n-Alfageme, S. and {\'A}lvarez-G{\'o}mez, J.A. and Rodr{\'\i}guez-Peces, M. and P{\'e}rez-L{\'o}pez, R. and Rodr{\'\i}guez-Pascua, M.A. and Masana, E. and Perea, H. and Mart{\'\i}n-Gonz{\'a}lez, F. and Giner-Robles, J. and Nemser, E.S. and Cabral, J.}
}
@article {Perea2012,
	title = {{Quaternary active tectonic structures in the offshore Bajo Segura basin (SE Iberian Peninsula {\textendash} Mediterranean Sea)}},
	journal = {Natural Hazards and Earth System Science},
	volume = {12},
	number = {10},
	year = {2012},
	month = {oct},
	pages = {3151{\textendash}3168},
	abstract = {The Bajo Segura fault zone (BSFZ) is the northern terminal splay of the Eastern Betic shear zone (EBSZ), a large left-lateral strike-slip fault system of sigmoid geometry stretching more than 450 km from Alicante to Almera. The BSFZ extends from the onshore Bajo Segura basin further into the Mediterranean Sea and shows a moderate instrumental seismic activity characterized by small earthquakes. Nevertheless, the zone was affected by large historical earthquakes of which the largest was the 1829 Torrevieja earthquake (<I>I</ I>EMS98 X). The onshore area of the BSFZ is marked by active transpressive structures (faults and folds), whereas the offshore area has been scarcely explored from the tectonic point of view. During the EVENT-SHELF cruise, a total of 10 high-resolution single-channel seismic sparker profiles were obtained along and across the offshore Bajo Segura basin. Analysis of these profiles resulted in (a) the identification of 6 Quaternary seismo-stratigraphic units bounded by five horizons corresponding to regional erosional surfaces related to global sea level lowstands; and (b) the mapping of the active sub-seafloor structures and their correlation with those described onshore. Moreover, the results suggest that the Bajo Segura blind thrust fault or the Torrevieja left-lateral strike-slip fault, with prolongation offshore, could be considered as the source of the 1829 Torrevieja earthquake. These data improve our understanding of present deformation along the BSFZ and provide new insights into the seismic hazard in the area. {\textcopyright} 2012. Author(s) CC Attribution 3.0 License.},
	issn = {1684-9981},
	doi = {10.5194/nhess-12-3151-2012},
	url = {http://www.scopus.com/inward/record.url?eid=2-s2.0-84867926421\&partnerID=tZOtx3y1},
	author = {Perea, H. and Gr{\`a}cia, E. and Alfaro, P. and Bartolome, R. and Lo Iacono, C. and Moreno, X. and Masana, E.}
}
@article {Zitellini2009,
	title = {{The quest for the Africa{\textendash}Eurasia plate boundary west of the Strait of Gibraltar}},
	journal = {Earth and Planetary Science Letters},
	volume = {280},
	number = {1-4},
	year = {2009},
	month = {apr},
	pages = {13{\textendash}50},
	abstract = {The missing link in the plate boundary between Eurasia and Africa in the central Atlantic is presented and discussed. A set of almost linear and sub parallel dextral strike-slip faults, the SWIM11SWIM is the acronym of the ESF EuroMargins project "Earthquake and Tsunami hazards of active faults at the South West Iberian Margin: deep structure, high-resolution imaging and paleoseismic signature". Faults, that form a narrow band of deformation over a length of 600~km coincident with a small circle centred on the pole of rotation of Africa with respect to Eurasia, was mapped using a new swath bathymetry compilation available in the area offshore SW Portugal. These faults connect the Gloria Fault to the Rif-Tell Fault Zone, two segments of the plate boundary between Africa and Eurasia. The SWIM faults cut across the Gulf of Cadiz, in the Atlantic Ocean, where the 1755 Great Lisbon earthquake, M \~{} 8.5-8.7, and tsunami were generated, providing a new insight on its source location. {\textcopyright} 2008 Elsevier B.V. All rights reserved.},
	keywords = {Africa-Eurasia plate boundary, Great Lisbon Earthquake, Gulf of Cadiz, Iberia, Nubia},
	issn = {0012821X},
	doi = {10.1016/j.epsl.2008.12.005},
	url = {http://www.scopus.com/inward/record.url?eid=2-s2.0-62749129333\&partnerID=tZOtx3y1},
	author = {Zitellini, N. and Gr{\`a}cia, E. and Matias, L. and Terrinha, P. and Abreu, M.A. and DeAlteriis, G. and Henriet, J.P. and Da{\~n}obeitia, J.J. and Masson, D.G. and Mulder, T.}
}
@article {Kaser2008,
	title = {{Quantitative accuracy analysis of the discontinuous Galerkin method for seismic wave propagation}},
	journal = {Geophysical Journal International},
	volume = {173},
	number = {3},
	year = {2008},
	month = {jun},
	pages = {990{\textendash}999},
	abstract = {We present a quantitative accuracy analysis of the Discontinuous Galerkin Finite-Element method for the simulation of seismic wave propagation on tetrahedral meshes. Several parameters are responsible for the accuracy of results, such as the chosen approximation order, the spatial discretization, that is, number of elements per wavelength, and the propagation distance of the waves due to numerical dispersion and dissipation. As error norm we choose the time-frequency representation of the envelope and phase misfit of seismograms to assess the accuracy of the resulting seismograms since this provides the time evolution of the spectral content and allows for the clear separation of amplitude and phase errors obtained by the numerical method. Our results can be directly used to set up the necessary modelling parameters for practical applications, such as the minimum approximation order for a given mesh spacing to reach a desired accuracy. Finally, we apply our results to the well-acknowledged LOH.1 and LOH.3 problems of the SPICE Code Validation project, including heterogeneous material and the free surface boundary condition, and compare our solutions with those of other methods. In general, we want to stress the increasing importance of certain standard procedures to facilitate future code validations and comparisons of results in the community of numerical seismology. {\textcopyright} 2008 The Authors Journal compilation {\textcopyright} 2008 RAS.},
	keywords = {Computational seismology, Numerical approximations and analysis, Numerical solutions, Time series analysis, Wave propagation, Wavelet transform},
	issn = {0956540X},
	doi = {10.1111/j.1365-246X.2008.03781.x},
	url = {http://www.scopus.com/inward/record.url?eid=2-s2.0-43749087643\&partnerID=tZOtx3y1},
	author = {K{\"a}ser, Martin and Hermann, Verena and de la Puente, Josep}
}
